so I started the install today after work. Sorry no pics. There are four big speakers and 3 little ones to put it simply. Two of the "little" speakers had extra connectors for the tweeter. So as Technic mentioned, simple once you take the OEMS out.
Center channel: was the most straight forward since it was the only little speaker without extra component wires. Popped that in with no issues.
The Other little speakers had to be the rear components. I verified this with Jason @ bsw who pointed out that the speakers with a flush lip would be the rears. (The others have a 1/2 lip above the speaker).
Once I removed the rear driver and tweeter it was a simple drop in.
Curiosity got the best of me, so I listed to each speaker (I only so far installed the center channel and right side rear deck component) before I screwed everything back in. The BSW's sounded "lower" than the stocks individually. Now this could be because:
a)they need to break in
b)higher rms, lower sensitivity.. need moar amp powah
c)different material, I'm just mistaking the "harshness" of the oems for extra loudness.
d)that^
e)all the above
In any case, it's not fair to judge with 2 whole speakers plugged in so I'll finish up tomorrow and have a listen see.
I guess I'll try (no promises
) to take some pics of the remaining install.